Criteria For Stroke Initiation - Siemens SINUMERIK 802D sl Function Manual

Punching and Nibbling (N4)
15.2 Stroke control
15.2.3

Criteria for stroke initiation

Initiate a stroke
The stroke initiation must be set, at the earliest, for the point in time at which it can be
guaranteed that the axes have reached a standstill. This ensures that at the instant of
punching, there is absolutely no relative movement between the punch and the metal sheet
in the machining plane.
The following diagram shows the various criteria that can be applied to stroke initiation.
Figure 15-2 Signal chart: Criteria for stroke initiation
The time interval between t
setting of output A
dead times.
The diagram above shows the default setting with which the output is set when the "Exact
stop fine window" is reached (
t'' and t'
1
268
and t
1
. This cannot be altered, but can be utilized as a lead time for minimizing
0
G601
are programmed by means of
1
is determined by the reaction of the punching unit to
2
; default setting of G group 12). The punch initiation times
and (see table below).
G602 G603
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Turning, Milling, Nibbling