Siemens SINUMERIK 802D sl Function Manual page 309

Initialization
The function is activated by the positive edge of the V380x 3000.7 signal (start positioning
axis). The interface signal must remain at logical "1" until the function has been
acknowledged positively or negatively by the following interface signals:
● V390x 3000.6 = 1 (position reached)
● V390x 3000.1 = 1 (error during traversing)
● V390x 3000.0 = 1 (axis cannot be started)
IS V390x 3000.7 = 1 (Positioning axis active) indicates that the function is active and that the
output signals are valid.
Figure 17-1 Pulse diagram normal condition
1. First function activation via positive edge of
2.
3. Positive acknowledgement
4. Reset function activation after receipt of acknowledgment
5. Signal change via function
6. Second function activation via positive edge of
7.
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Positioning axis active
valid
Positioning axis active
valid
Start
= 1 shows that the function is active and that the output signals are
Position reached
= 1 and
= 1 shows that the function is active and that the output signals are
Positioning Axes (P2)
17.2 Permanently assigned PLC axis
positioning axis active
Start
= 1
309