Siemens SINUMERIK 802D sl Function Manual page 180

Operating Modes, Program Operation (K1)
10.3 Processing a part program
Table 10- 8 Sequence at part program end
Seque Command
nce
1 Channel selection: Reset status
Operating mode selection: AUTO or
AUTO and overstoring or
MDA or TEACH IN
2
3 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
4 /_N_CMA_DIR/_N_PROG_EVENT_SPF or
name from MD11620
5 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
Event
Operator panel reset
Table 10- 9 Processing sequence in operator panel reset
Seque Command
nce
1 Selection of channel and mode:
2
3 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
4 /_N_CMA_DIR/_N_PROG_EVENT_SPF or
name from MD11620
5 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
Event
Startup
180
NC Start
any
Reset
Boundary conditions
(must be satisfied before the
command)
None
Block with end of part program
Control activated:
Reset sequence with evaluation
as an ASUB
Control activated:
Reset sequence with evaluation
Boundary conditions
(must be satisfied before the
command)
Initial state: Any mode, any
channel status
Control activated:
Reset sequence with evaluation
as an ASUB
Control activated:
Reset sequence with evaluation
Comments
Select channel and mode
Block is changed
Implied call of the path name as
an ASUB
The G code reset position
continues to be specified with
machine data
Comments
Select mode / channel status
any state
Implied call of the path name as
an ASUB
The G code reset position
continues to be specified with
machine data
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
from