Axis Start After Punching - Siemens SINUMERIK 802D sl Function Manual

Punching and Nibbling (N4)
15.2 Stroke control
15.2.4

Axis start after punching

Input signal "Stroke ON"
The start of an axis motion after stroke initiation is controlled via input signal "Stroke ON".
Figure 15-3 Signal chart: Axis start after punching
In this case, the time interval between t
time. It is determined by the interpolation sampling time and the programmed
punching/nibbling mode.
PON/SON
When the punching unit is controlled via
|t' - t
4
PONS/SONS
If the punch is controlled by
|t' - t
4
Prerequisites: Stroke time (t
270
| = 3 x interpolation cycles
4
| ≤ 3 x position controller cycles
4
and t' acts as a switching-time-dependent reaction
4 4
/ , the maximum delay time is calculated to be:
PON SON
/ , the delay time is determined by:
PONS SONS
- t ) > 4 interpolation cycles
4 2
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
t
t