Siemens SINUMERIK 802D sl Function Manual page 181

Table 10- 10 Sequence with Powerup
Seque Command
nce
1
2 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
3 /_N_CMA_DIR/_N_PROG_EVENT_SPF or
name from MD11620
4 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
Chronological sequences
For part program start and part program end:
Time sequence of VDI signals VB3300 0003 ("Program status" and "Channel status") when
processing a part program with an event-driven program call for part program start and part
program end:
Program status
Running
(V3300 0003.0)
Stopped
(V3300 0003.2)
Aborted
(V3300 0003.4)
Channel status
Active
(V3300 0003.5)
Interrupted
(V3300 0003.6)
Reset
(V3300 0003.7)
Figure 10-1
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Reset
Part _N_PROG_
program EVENT_SPF
Start End
Time sequence of the interface signals for program status and channel status (1)
Operating Modes, Program Operation (K1)
Boundary conditions
(must be satisfied before the
command)
after power up
Control activated
after ramp up:
Reset sequence with evaluation
as an ASUB
Control activated:
Reset sequence with evaluation
Part
program
End
10.3 Processing a part program
Comments
Implied call of the path name as
an ASUB
The G code reset position
continues to be specified with
machine data
_N_PROG_ _N_PROG_
EVENT_SPF EVENT_SPF
Active End
181