Setting Warning And Trip Limits - Siemens SINUMERIK 802D sl Function Manual

● Start gantry synchronization. PLC sets:
6.7.4

Setting warning and trip limits

As soon as the gantry grouping is set and synchronized, the following machine data must
still be set to correspond:
MD37110 GANTRY_POS_TOL_WARNING (gantry warning limit)
MD37120 GANTRY_POS_TOL_ERROR (gantry trip limit)
Proceed as follows
● Set the machine data for all axes with a large value to begin with:
● Set a very small value in the machine data:
● Now increase MD37110.
● Enter the value calculated for the warning limit + a small buffer value for safety purposes
Error limit values
Values are entered in the following machine data:
MD37110 GANTRY_POS_TOL_WARNING (gantry warning limit)
MD37120 GANTRY_POS_TOL_ERROR (gantry trip limit)
MD37130 GANTRY_POS_TOL_REF (gantry trip limit for referencing)
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Continue with Step 1 (see above).
V380x 5005.4 = 1 (start gantry synchronization)
MD37120 GANTRY_POS_TOL_ERROR (gantry trip limit)
MD37110 GANTRY_POS_TOL_WARNING (gantry warning limit)
When you put a heavy, dynamic strain on the axes, always be careful to re-enter the self-
canceling alarm "10652 channel %1 axis %2 gantry warning limit exceeded".
Do this until the alarm no longer appears. The interface indicates the status specified
below. (That must occur in the appropriate window, according to production.)
in machine data MD37120:
Gantry axes (G1)
6.7 Example
111