Rear Panel - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
Name
RST button

2.1.7.3 Rear Panel

The rear panel of the USG6306/6308/6330/6350/6360 provides the power module, protective
ground terminal, and hard disk slot for optional hard disk combination.
Figure 2-29
Figure 2-29 USG6306/6308/6330/6350/6360 rear panel
SM-HDD-SAS300G-B
Hard disk combination (optional)
Name
Slot numbering
Power modules (in slots
PWR5 and PWR6)
Issue 08 (2017-06-30)
Description
To restart the device, press the RST button. Ensure that the running
configuration is saved before pressing the RST button.
The RST button can also be used to restore the default settings. To do
so, press and hold down the RST button and power on the device. When
the MODE indicator of the fixed interface board blinks (about 3 to 5
seconds later), release the button. The device then starts with the default
configuration.
NOTE
If the device has a hard disk installed, before pressing the RST button to reset,
run the disk offline command in the user view. Wait about 30 seconds until the
system indicates that the hard disk stops working and then press the RST button.
Otherwise, the data may be lost or hard disk be damaged.
illustrates the rear panel of the USG6306/6308/6330/6350/6360.
4 HDD
Description
Indicates the layout of the slots, including the slot number and
module type.
Provides power input and distribution for the device. PWR5 is
the standard power module, which is built-in and not
pluggable. An optional PWR6 power module is supported to
provide 1+1 power redundancy. When PWR5 is working,
PWR6 is hot-swappable. For details, see
System.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OUTPUT
ON
XXXXXXXXXXXXXXXXXXXXXXXXXXX
OFF
ESN Power module
Protective ground terminal
Slot numbering layout
5 PWR 6 PWR
2 Hardware Overview
Secospace USG6000
4 HDD
~100-240V;50/60Hz;2.5A
Slot for optional
power module
2.1.7.4 Power Supply
5 PWR 6 PWR
55