Connecting Dc Power Cables - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
----End
Follow-up Procedure
Verify the following after the connection is complete:
l
l

3.5.8.2 Connecting DC Power Cables

In standard configuration, the USG6660/6670/6680 has two DC power supply modules. Each
module requires a PGND cable, an NEG DC power cable, and an RTN DC power cable. This
section describes how to connect power cables to the two DC supply modules.
Context
Before connecting power cables, ensure that the DC power supply in the equipment room
meets the input requirements of the USG.
Issue 08 (2017-06-30)
Figure 3-73 Connecting the AC power cable
STATUS
PAC-700WA-L
HDD0
SPUA
SPUB
AC power cable
AC power supply A
1
The power cable is firmly connected to the power supply socket.
If multiple USGs are deployed, the power cables of each USG are correctly labeled for
distinction.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
~100-240V;50/60Hz,10A
STATUS
~100-240V;50/60Hz,10A
PAC-700WA-L
HDD1
EN EN
0
MGMT CONSOLE
2
3 Hardware Installation
FAN STATUS
9 PWR 10 PWR 13
F
~100-240V;50/60Hz,10A
11 SPU
A
12 SPU
N
SYS ALM MODE
RST
RUN ALM
FAN
AC power cable
AC power supply B
3
330