Connecting An Ethernet Cable - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
For details on the console login, refer to the Administrator Guide.

3.3.4 Connecting an Ethernet Cable

Based on the network plan, you can connect one end of an Ethernet cable to the Ethernet port
of a USG6310/6320 and the other end to the Ethernet port of the peer device.
Context
Before connecting the Ethernet cable, perform the following operations:
l
l
l
Issue 08 (2017-06-30)
Figure 3-32 Setting the PuTTY parameters for connecting the serial port to the
USG
d. Click Open. The copyright information is displayed on the HyperTerminal. You can
enter default user name admin and password Admin@123, modify the default
password as prompted to log in to the USG CLI.
Check construction conditions.
The peer device has been installed in the equipment room, and the port to which the
Ethernet cable is to be connected has been determined.
Check the cabling route.
The engineering document should specify the cabling route from the cabinet to the peer
device in the equipment room, and the length of the cable is calculated based on the
cabling path.
Label the cable.
The cable must be labeled before being connected to the devices.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
281