Connecting Power Cables; Connecting Ac Power Cables - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
l
l
l

3.5.8 Connecting Power Cables

Follow the power supply reference of the USG to connect the power supply module of the
USG to the output of the power supply device.

3.5.8.1 Connecting AC Power Cables

In standard configuration, the USG has two AC power supply modules. Each module requires
a power cable. This section describes how to connect power cables to the two AC supply
modules.
Context
Before connecting the power cables, ensure that the AC power supply in the equipment room
meets the input requirements of the USG.
Do not connect or disconnect the power cables when the USG is powered on.
Procedure
Step 1 Ensure that the PGND cable is properly grounded.
Step 2 Ensure that the power switch of the USG is OFF.
Step 3 Connect the power cables to both AC power supply modules one after the other.
1.
2.
3.
4.
Issue 08 (2017-06-30)
The optical fiber is improperly inserted. Pull out the optical fiber and re-insert it.
The RX and TX optical ports are inserted reversely. Pull out the optical fibers, change
their position, and re-insert them.
The optical module is damaged or the optical fiber is broken. Replace the optical module
or the optical fiber.
DANGER
NOTE
To increase availability, connect the two power supply modules to different power supplies.
Insert the power cable retention clip to the socket next to the power socket.
Insert a C13 receptacle of the power cable delivered with the USG into the socket of the
power supply module on the USG. And adjust the cable retention clip to a ring of the
proper size.
Slide the ring along the AC power cable and adjust the ring to tighten the cable.
Connect the other receptacle of the AC power cable to the socket or output terminal of
the AC power supply device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
329