Installing A Micro Sd Card - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
Procedure
Step 1 Loosen and remove the screw of the ground terminal on the USG rear panel.
Step 2 Align the M4 end of the PGND cable with the screw hole of the ground terminal and tighten
the screw.
Step 3 Connect the M6 end of the PGND cable to the ground terminal of the cabinet, workbench, or
wall.
Figure 3-10 Connecting a PGND cable
Workbench ground point
----End
Follow-up Procedure
Verify the following after the cabling is complete:
l
l

3.2.3 Installing a Micro SD Card

This section describes how to install a micro SD card for the first time to avoid damages.
Context
Instruments required:
l
l
Issue 08 (2017-06-30)
Secospace USG6000
LTE DIV WiFi 0
micro SD
XXXXXXXXXXXXXXXXXXXXXXXXXXX
Cabinet ground point
Wall ground point
1
The PGND cable is securely connected to the ground terminal.
The electrical resistance between the ground terminal and ground point is less than 5
ohm on a multimeter.
Phillips screwdriver
ESD wrist strap
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 7
1 3
WiFi 1
0 2 4 6
CONSOLE
PGND cable
2
3 Hardware Installation
LTE MAIN
RST
12V ; 2A
3
254