Installing A Sim Card (Usg6310S-Wl-Ovs/6510-Wl) - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
Figure 3-11 Installing the micro SD card and anti-theft board
LTE DIV
----End
Follow-up Procedure
After the micro SD card is installed, power on the USG and run the display sd-card
information command in any view to check the micro SD card installation and file system
mounting status. If SD Card Physical State is Present and SD Card File System State is
Mounted, the micro SD card is working properly.
l
l

3.2.4 Installing a SIM Card (USG6310S-WL-OVS/6510-WL)

The USG6310S-WL-OVS/6510-WL provides an internal LTE module which provides the
LTE access function. To use the LTE access function, install the SIM card as instructed.
Context
Instruments required:
l
l
Issue 08 (2017-06-30)
micro SD
Secospace USG6000
WiFi 0
micro SD
XXXXXXXXXXXXXXXXXXXXXXXXXXX
1
micro SD
If SD Card Physical State is Absent, re-install the micro SD card and try again. If SD
Card Physical State remains the same, the USG may fail to identify the micro SD card.
You are advised to use another micro SD card.
If SD Card File System State is Unmounted, the micro SD card format might not be
ext4. You need to run the reset sd-card command in the system view to format the
micro SD card.
Phillips screwdriver
ESD wrist strap
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 3 5 7
WiFi 1
0 2 4 6
CONSOLE
2
micro SD
3 Hardware Installation
LTE MAIN
RST
12V ; 2A
3
micro SD
256