Installing An Expansion Card - Huawei USG6000 Series Hardware Manual

Version v100r001 & v500r001
Hide thumbs Also See for USG6000 Series:
Table of Contents

Advertisement

HUAWEI USG6000 Series
Hardware Guide
Follow-up Procedure
Verify the following after the cabling is complete:
l
l

3.4.3 Installing an Expansion Card

This section describes how to install an expansion card and avoid any damage.
Context
l Expansion cards are not hot-swappable. Do not power on the USG before you install any
l Before you hold expansion cards, make sure that you are wearing an ESD wrist strap and
Before installing the expansion card, complete the following steps:
l
l
l
Procedure
Step 1 Determine the slot in which an expansion card is to be installed and note the slot number. For
details, see the slot numbers on the front panel of the USG.
Step 2 Install a WSIC expansion card, as shown in
1.
2.
3.
Issue 08 (2017-06-30)
The PGND cable is securely connected to the ground terminal.
The electrical resistance between the ground terminal and ground point is less than 5
ohm on a multimeter.
NOTICE
expansion card.
that the strap is well grounded to protect the expansion cards.
Have the following instruments ready:
– Phillips screwdriver
– ESD wrist strap
Check the expansion card as follows:
– Check whether the expansion card models match the labels on the packing boxes.
– Check whether the expansion cards are damaged or have loose components.
If the expansion card models are not the same as that labeled on the packing boxes, the
card is damaged, or certain components are loosened, contact Huawei technical support
engineers.
Before you install an expansion card, check whether the USG supports this card. For
details on the hardware description of supported expansion cards, see Ports in Device
Overview.
Loosen screws on the filler panel of a WSIC slot and remove the filler panel.
Open the ejector lever on an expansion card and push the expansion card along the guide
rails of the slot until the ejector lever touches the front panel.
Push the ejector lever inward until the expansion card is well seated into the slot, and
tighten screws on both sides of the expansion card.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
3-47.
3 Hardware Installation
295

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents