Rear Panel - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
Name
RST button

2.1.9.3 Rear Panel

The rear panel of the USG6390E provides the power module, protective ground terminal, and
hard disk slot for optional hard disk combination.
Figure 2-42
Figure 2-42 USG6390E rear panel
SM-HDD-SAS300G-B
Hard disk combination (optional)
Name
Slot numbering
Power modules (in slots
PWR5 and PWR6)
Issue 08 (2017-06-30)
Description
To restart the device, press the RST button. Ensure that the running
configuration is saved before pressing the RST button.
The RST button can also be used to restore the default settings. To do
so, press and hold down the RST button and power on the device. When
the MODE indicator of the fixed interface board blinks (about 3 to 5
seconds later), release the button. The device then starts with the default
configuration.
NOTE
If the device has a hard disk installed, before pressing the RST button to reset,
run the disk offline command in the user view. Wait about 30 seconds until the
system indicates that the hard disk stops working and then press the RST button.
Otherwise, the data may be lost or hard disk be damaged.
illustrates the rear panel of the USG6390E.
4 HDD
Description
Indicates the layout of the slots, including the slot number and
module type.
Provides power input and distribution for the device. One
power module is provided by default, but two power modules
are supported to provide 1+1 power redundancy. If two power
modules are used and one power module fails, the other can
support the entire system so that you can replace the faulty
power module without interrupting device operation. For
details, see
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
INPUT OUTPUT
ON
XXXXXXXXXXXXXXXXXXXXXXXXXXX
OFF
ESN Power module
Protective ground terminal
Slot numbering layout
5 PWR 6 PWR
2.1.9.3 Rear Panel.
2 Hardware Overview
Secospace USG6000
4 HDD
~100-240V;50/60Hz;2.5A
Slot for optional
power module
5 PWR 6 PWR
86