Mounting A Device To A Specified Location; Mounting A Device In A Cabinet - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide

3.3.1 Mounting a Device to a Specified Location

The USG6310/6320 can be mounted in a 19-inch standard cabinet. When no cabinet is
available, install the USG6310/6320 on a workbench or a wall.

3.3.1.1 Mounting a Device in a Cabinet

The USG6310/6320 can be mounted in a 19-inch standard cabinet using mounting ears.
Context
Required instruments:
l
l
Before installing the USG, check the following items:
l
l
l
l
l
You can place either end of the USG chassis towards the cabinet door. In this manual, the rear
panel of the USG is towards the cabinet door.
Procedure
Step 1 Install mounting ears on the chassis.
Use a Phillips screwdriver to fix the mounting ears to both sides of the chassis with M4
screws, as shown in
Issue 08 (2017-06-30)
Phillips screwdriver
Floating mounting bar
The cabinet is stable.
The position for the USG in the cabinet is well arranged.
Ensure that the USG is 1 U of clearance from any devices above and below and 150 mm
of clearance from any devices on the right or left.
The device to be installed is staged near the cabinet for convenience.
From the rear perspective of the chassis, the cooling wind of the USG flows in on the left
and is exhausted on the right. When a USG and a device whose cooling wind flows in on
the right and is exhausted on the left are installed in the same cabinet, adequate space
must be reserved between them to avoid thermal cycles.
Figure
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-21.
3 Hardware Installation
270