Power Supply System - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
Name
USB 2.0 port
SIM card slot
Micro SD card
slot
Console port
(RJ45)
0 to 7 (RJ45)
RST button
Power
receptacle
Protective
ground terminal
Clip hole

2.2.2.4 Power Supply System

The USG6510-WL does not have a built-in power module and requires an external 24W
power adapter.
Issue 08 (2017-06-30)
Description
l USB ports allow you to insert USB devices for system software
upgrades. For details on upgrades through USB devices, refer to the
Upgrade Guide delivered with the device.
l USB ports allow you to insert 4G LTE data cards. For details on the
4G LTE data cards, refer to
The SIM card slot allows you to insert a standard SIM card. The slot
supports such standards as 4G FDD LTE/TDD LTE, 3G TD-SCDMA/
WCDMA, and 2G GSM.
The micro SD card slot allows you to insert a micro SD card to record
logs and reports in real time. The micro SD card is optional. You can
purchase one (BOM code: 06010308, model: SDSDQAE-064G,
capacity: 64GB, dimensions (H x W x D): 1 mm x 15.00 mm x 11.00
mm) from Huawei if needed.
You are advised to install an anti-theft board delivered with the device
to protect the micro SD card.
Console ports allow you to locally connect a PC to the device.
You can use a console cable to connect the console port (RJ45) on the
device to the COM port on your PC and use a serial port terminal
program on your PC to access, configure, and manage the device.
8 10/100/1000M autosensing Ethernet electrical ports, numbered from
GigabitEthernet 0/0/0 to GigabitEthernet 0/0/7.
GigabitEthernet 0/0/0 is an inband management port and its default IP
address is 192.168.0.1. After this port is connected to your PC through
network cables, you can log in to the device using Telnet, STelnet, or
web UI to configure or manage the device.
To restart the device, press the RST button. Ensure that the running
configuration is saved before pressing the RST button.
The RST button can also be used to restore the default settings. To do
so, press and hold down the RST button and power on the device. Three
to five seconds later, when the SYS and ALM indicators on the front
panel are both blinking, release the RST button.
Connects to the 4-pin plug of the power adapter.
The M4 OT terminal connects the PGND cable to the ground point of
the cabinet, workbench, or wall, or the ground bar in an equipment
room.
The hole is used to install the power cable clip, which is used to bind
and fix the power cable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Hardware Overview
2.6 4G LTE Data Card.
104