Replacing A Sim Card (Usg6310S-Wl-Ovs/6510-Wl) - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
Figure 4-28 Installing the new micro SD card and anti-theft board
LTE DIV
Step 4 In any view, run the display sd-card information command to check the micro SD card
installation and file system mounting status. In the command output, SD Card Physical State
should be Present, and SD Card File System State should be Mounted.
l
l
----End

4.7 Replacing a SIM Card (USG6310S-WL-OVS/6510-WL)

If the SIM card is damaged or needs to be replaced with a SIM card with different standards,
follow the instructions in this section.
Context
Instruments required:
l
l
Issue 08 (2017-06-30)
micro SD
Secospace USG6000
WiFi 0
micro SD
XXXXXXXXXXXXXXXXXXXXXXXXXXX
1
micro SD
If SD Card Physical State is Absent, re-install the micro SD card and try again. If SD
Card Physical State remains the same, the USG may fail to identify the micro SD card.
You are advised to use another micro SD card.
If SD Card File System State is Unmounted, the micro SD card format might not be
ext4. You need to run the reset sd-card command in the system view to format the
micro SD card.
Phillips screwdriver
ESD wrist strap
NOTE
l The USG6310S-WL-OVS/6510-WL supports standard SIM cards. If the SIM card type is Micro or
Nano, you need to purchase a SIM card tray. Because the SIM card tray and SIM card are bound
through tapes, the surface might not be smooth. Exercise caution when you remove and insert the
SIM card.
l The USG6310S-WL-OVS/6510-WL supports 4G FDD LTE/TDD LTE, 3G TD-SCDMA/WCDMA,
and 2G GSM SIM cards. You need to purchase the corresponding SIM card.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 3 5 7
WiFi 1
0 2 4 6
CONSOLE
2
micro SD
4 Maintaining the Hardware
LTE MAIN
RST
12V ; 2A
3
micro SD
368