Instruments Required For The Installation - Huawei USG6000 Series Hardware Manual

HUAWEI USG6000 Series
Hardware Guide
Check Item
Surge protection
Power supply facility
Electromagnetic shielding

3.1.3 Instruments Required for the Installation

This section describes the instruments and meters for installing the USG.
Table 3-2
Table 3-2 Required instruments and meters
Category
Measuring and
lineation instruments
Fastening tools
Drilling tools
Pliers
Auxiliary tools
Issue 08 (2017-06-30)
Requirement
Complies with requirements
in
Protection and
Complies with requirements
in
Complies with requirements
in
Protection.
lists the required instruments and meters for USG installation.
Instrument/Meter
l Ruler: used to measure length.
l Marker: used to indicate specific lengths with drawn lines.
l Flat-head screwdriver: used to fasten small screws and bolts.
l Phillips screwdriver: used to fasten small screws and bolts.
l Hammer drill: used to drill mounting holes during wall-
mounting.
l Vacuum cleaner: used to remove dust and debris produced
while drilling holes.
l Hammer: used to drive the hollow wall anchors into mounting
holes.
l Needle-nose pliers: used to hold small fittings and twist fine
wires in a narrow workplace.
l Diagonal cutting pliers: used to cut insulated sleeves and tie
wraps.
l Knife: used to peel the insulated sleeve from the cable.
l Ladder: used to access overhead cabling.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
A.3.4 Lightning
Grounding.
A.3.5 Power Supply.
A.3.6 Electromagnetic
3 Hardware Installation
Compliance
□ Y □ N □ N/A
□ Y □ N □ N/A
□ Y □ N □ N/A
244