Huawei USG6000 Series Hardware Manual page 293

HUAWEI USG6000 Series
Hardware Guide
l
l Make sure that the PC and the USG are connected to the same ground point. Otherwise,
l Pay attention to port numbering and make sure that the cable is connected to the correct
Procedure
Step 1 Before connecting a console cable, attach temporary labels to both ends of the cable for
identification.
Step 2 Connect the RJ45 connector of the console cable to the console port (RJ45) of the USG.
Step 3 Connect the DB9 connector of the console cable to the COM port of the management PC.
Figure 3-31 Connecting a console cable to the USG
CONSOLE
Step 4 Remove the temporary labels and attach labels 2 cm away from connectors at both ends of the
console cable.
----End
Follow-up Procedure
After the cable connection is complete, verify that:
l
Issue 08 (2017-06-30)
A PC is ready, a USG has been installed, and the ports to be connected are planned.
Prepare cable labels.
Before cable connection, labels must be prepared for the cable.
NOTICE
the console port of the USG may be damaged.
port, preventing damage to ports or the device.
NOTE
You can purchase the console cable as required.
CONSOLE
XXXXXXXXXXXXXXXXXXXXXXXXXXX
Console configuration cable
The labels at both ends of a cable are correct, clear, neat, and facing the same direction.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Secospace USG6000
1 3 5 7
RST
0 2 4 6
3 Hardware Installation
COM port
12V ; 3A
279