Cutting Unit Drive Shafts - Toro Groundsmaster 1200 Service Manual

Cutting Unit Drive Shafts

g241350
1. Cutting unit gear box
2. Quick release pin
Removing the Cutting Unit Drive Shafts
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack; refer to the
Groundsmaster 1200 Operator's Manual.
Support the drive shaft (weighs approximately 16 Kg (36 lb)) to
prevent it from dropping and causing personal injury when removing.
Figure 33
3. Cutting unit drive shaft
4. Center gear box
WARNING
Page 5–5 Cutting Unit Drive: Service and Repairs