Toro Groundsmaster 1200 Service Manual page 90

Removing the Deck Mount Assembly (continued)
Cutting Units: Service and Repairs
5. Disconnect the impact arm assembly (1) from cutting unit assembly (14) by
removing the nut (3), spacers (3) and bolt (2); refer to
Arm Assembly (page
6. Remove the lift arm assembly (10) from the cutting unit assembly (14); refer
to Removing the Lift Arm Joint Yoke (page 3–14)
Cutting Unit Lift Arm Assembly (page
7. Remove the nuts (8 and 12), bolts (9), and carriage bolts (13) that secures
the deck mount assembly (11) to the cutting unit (14).
Make sure that the hoist or lift used to remove the deck mount
assembly (weighs approximately 75 Kg (165 lb)) can properly
support the deck mount assembly with gear box.
8. Connect the suitable hoist or lift to the deck mount assembly. Lift and remove
the deck mount assembly (11) from the cutting unit assembly (14).
9. Remove the cutting unit gear box from the deck mount assembly. Refer to
Removing the Cutting Unit Gear Box (page
g264170
1. Flange nut (2 each)
2. Bolt (2 each)
3. Deck stop assembly
10. If necessary, remove the 2 bolt (2) that secures the deck stop assembly
(3) to the deck mount assembly (6). Remove the deck stop assembly from
the deck mount assembly.
3–21).
3–18).
CAUTION
Figure 45
4. Bumper pad
5. Screw (2 each)
6. Deck mount assembly
Page 6–6 Groundsmaster® 1200 Pull-Behind Rotary Mower
Removing the Impact
and Removing the Rear
5–11).
18235SL Rev A