Blade Spindles - Toro Groundsmaster 1200 Service Manual

Blade Spindles

g241342
1. Ribbed neck bolt (8 each per
spindle)
2. Grease nipple
3. Left spindle assembly
4. Cutting unit
5. Blade bolt (3 each)
Removing the Blade Spindle
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
6. Anti-scalp cup (3 each)
7. Cutting blade (3 each)
8. Right spindle assembly
9. Idler assembly (2 each)
10. Center spindle assembly
Note: Refer to Figure 48
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack; refer to the
Groundsmaster 1200 Operator's Manual.
2. Remove the cutting unit covers from the top of the cutting unit.
3. Use a ⅜" or ½" drive ratchet or breaker bar to relieve idler pulley tension and
remove drive belt(s) (12) from spindle to be serviced.
Figure 48
11.
12.
13.
during this procedure.
Page 6–11
Drive pulley
Drive belt (2 each)
Flange nut (24 each)
Cutting Units: Service and Repairs