Toro Groundsmaster 1200 Service Manual page 84

Removal of Center Gear Box (continued)
Installing the Center Gear Box
Cutting Unit Drive: Service and Repairs
6. If necessary, remove and replace the oil seals in the center gear box.
Note: The gear box replacement is necessary as the internal gear box
components are not available separately.
g263989
1. Input shaft
2. Output shaft to left cutting unit
3. Output shaft to rear cutting unit (no bolts
surface)
1. If oil seals were removed from the center gear box, install new seals to the
center gear box. Make sure that the center gear box is filled with 2.48 L (2.6
qt) of Toro premium tractor fluid or Mobil 424.
2. Position the center gear box assembly (item 2 in
(3); refer to Figure
box.
3. Secure the center gear box assembly (2) to the frame (3) with the 4 bolts
(1) and 4 washers (4). Alternately and evenly torque the bolts to 183 to
224 N·m (135 to 165 ft-lb).
4. Connect the cutting unit drive shafts to the center gear box; refer to
the Cutting Unit Drive Shafts (page
5. Connect the main drive shaft to the center gear box; refer to
Main Drive shaft (page
Figure 43
4. Output shaft to right cutting unit
5. Dip stick
43. Ensure that the dip stick is facing topside of the gear
5–7).
5–4).
Page 5–16 Groundsmaster® 1200 Pull-Behind Rotary Mower
Figure 42) on to the frame
Installing
Installing the
18235SL Rev A