Toro Groundsmaster 1200 Service Manual page 97

Disassembling the Blade Spindle
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
g241361
1. Locknut
2. Special hardened washer
3. Pulley
4. O-ring
5. Oil seal (2 each)
Note: Refer to Figure 49
1. Remove the locknut (1) from the top of the spindle shaft (14).
2. Remove the special hardened washer (2) and pulley (3) from the shaft (14).
3. Use an arbor press to remove the spindle shaft (14) from the spindle housing
(9).
Note: Ensure that the spindle shaft spacer remains on the spindle shaft.
4. Remove the oil seals (5) from the spindle housing (9).
5. Remove the bearing set (6), O-ring (4), bearing spacer (7), and spacer ring
(12) from the spindle housing (9).
Figure 49
Low Spindle Assembly (shown)
6. Bearing set
7. Bearing spacer
8. Ribbed neck bolt (8 each) 13.
9. Spindle housing
10. Grease fitting
during this procedure.
Page 6–13
11. Large snap ring
12. Spacer ring
Shaft spacer
14. Spindle shaft
Cutting Units: Service and Repairs