Rollers - Toro Groundsmaster 1200 Service Manual

Rollers

g241360
1. Lock nut (8 each)
2. Skid assembly LH
3. Bearing shim (4 each)
4. Flange bushing (4 each)
Removing the Rollers
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
5. Bolt (8 each)
6. Grease fitting (4 each)
7. Nut (4 each)
8. Carriage bolt (4 each)
Note: Refer to Figure 55
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack; refer to the
Groundsmaster 1200 Operator's Manual.
2. Loosen the set screws in the collars of the roller bearings.
3. Loosen and remove the nuts (7) and carriage bolt that secures the LH skid
assembly (2) to the cutting unit (10).
4. Remove the LH skid assembly (2) from the cutting unit assembly (10).
5. Slide and remove the roller assembly (9) from the cutting unit assembly (10).
6. If necessary, remove the nuts (1), bolts (5), flange bushing (4) and bearing
shim (3) from the LH skid assembly (2).
7. Loosen and remove the grease fittings (6) from the flange bushing (4).
Figure 55
10.
during this procedure.
Page 6–19
9. Roller assembly
Cutting unit assembly
Cutting Units: Service and Repairs