Table of Contents
Advertisement
Removing the Cutting Unit Drive Shafts (continued)
Cutting Unit Drive: Service and Repairs
g263855
1.
Cutting unit gear box
2.
Clamp (2 each)
2. Disconnect the cutting unit drive shaft (3) from the centre gear box shaft
(4) as follows:
A. Loosen the clamp (2) and slide the shield cone (10) on the cutting unit
drive shaft (3).
B. Press and hold the quick release pin and (2) on the end yoke (11) of the
cutting unit drive shaft (3).
C. Slide the cutting unit drive shaft (3) from the center gear box shaft (4).
Support the drive shaft (weighs approximately 16 Kg (36 lb)) to
prevent it from dropping and causing personal injury when removing.
3. Disconnect the cutting unit drive shaft (3) from the cutting unit gear box (1).
A. Loosen the clamp (2) and slide the shield cone (2) on the cutting unit
drive shaft (3).
B. Press and hold the quick release pin (2) on the end yoke (1) of the cutting
unit drive shaft (3).
C. Slide the cutting unit drive shaft (3) from the cutting unit gear box shaft (1).
4. Repeat steps
2
and
5. Repeat steps
2
and
Figure 34
3.
Cutting unit drive shaft
4.
Main gear box
WARNING
3
for the left hand drive shaft.
3
for the rear drive shaft.
Page 5–6
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
Advertisement
Chapters
Table of Contents
