Service And Repairs; Wheels - Toro Groundsmaster 1200 Service Manual

Service and Repairs

Wheels

g241364
1. Wheel and tire assembly
2. Wheel lug nut (5 each per wheel)
Removing the Wheel
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack (refer to the
Groundsmaster 1200 Operator's Manual for further instructions on the proper
way to use the tow bar jack).
2. Block the wheel that you are not removing with chocks to prevent the
machine from moving.
3. Lift the machine from the ground and support the raised machine with a
jack stand (refer to the Groundsmaster 1200 Operator's Manual for further
instructions on the proper way to use jack stands).
4. Loosen but do not remove the 5 wheel-lug nuts (2) that secure the wheel
to the hub assembly.
Figure 7
3. Wheel hub assembly
4. Torsion axle
Page 3–3 Chassis: Service and Repairs