Toro Groundsmaster 1200 Service Manual page 104

Installing the Rollers
Cutting Units: Service and Repairs
1. If removed, install the grease fittings (6) on the flange bushing (4).
Replacement roller bearings include straight grease fittings. Fit 90°
grease fittings in bearings prior to installation. Position grease
fitting toward the outside of the cutting unit.
2. If removed, install the bearing shim (3), flange bushing (4), bolts (5) and nuts
(1) onto the LH skid assembly (2).
3. Slide the roller assembly (9) into the skid assemblies.
4. Install the LH skid assembly (2) to the cutting unit assembly (10) and secure
with the carriage bolts (8) and nuts (7). Tighten the nuts (7) to 40 to 47 N∙m
(29 to 35 ft-lb).
5. Center the roller between the skids and tighten the 2 set screws in each
roller bearing coller.
6. Check and adjust the height of cut and mower pitch; refer to the machine
Operator's Manual.
IMPORTANT
Page 6–20 Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A