Wheel Bearings - Toro Groundsmaster 1200 Service Manual

Wheel Bearings

g241363
1. Torsion axle
2. Oil seal
3. Bearing cone (2 each per axle)
4. Bearing cup (2 each per axle)
Disassembling the Wheel Bearings
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
5. Wheel hub
6. Spindle washer
7. Slotted nut
8. Dust cap
Note: Refer to Figure 8
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack (refer to the
Groundsmaster 1200 Operator's Manual for further instructions on the proper
way to use the tow bar jack).
2. Block the wheel that you are not removing with chocks to prevent the
machine from moving.
3. Lift the machine from the ground and support the raised machine with a
jack stand (refer to the Groundsmaster 1200 Operator's Manual for further
instructions on the proper way to use jack stands).
4. Remove the wheel.
5. Carefully remove the dust cap (8) from the wheel hub.
Figure 8
9.
10.
during this procedure.
Page 3–5
Drive studs (5 each per hub)
Cotter pin
Chassis: Service and Repairs