Deck Mount Assembly - Toro Groundsmaster 1200 Service Manual

Deck Mount Assembly

Removing the Deck Mount Assembly
Groundsmaster® 1200 Pull-Behind Rotary Mower
18235SL Rev A
g254260
1. Impact arm assembly
2. Bolt
3. Spindle spacer (2 each)
4. Lock nut
5. Nut
Note: Refer to Figure 44
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack; refer to the
Groundsmaster 1200 Operator's Manual.
2. Remove the cutting unit drive shafts; refer to
Drive Shafts (page
3. Remove the deck covers from the top of the cutting unit.
4. Use a ⅜" or ½" drive ratchet or breaker bar to relieve idler pulley tension
and remove the drive belt.
Figure 44
6. Hardened washer
7. Thrust washer
8. Nut (2 each)
9. Bolt (2 each)
10. Lift arm assembly
during this procedure.
5–5).
Page 6–5
11. Deck mount assembly
12. Nut (4 each)
13. Carriage bolt (4 each)
14. Cutting unit
Removing the Cutting Unit
Cutting Units: Service and Repairs