Idler Assemblies - Toro Groundsmaster 1200 Service Manual

Idler Assemblies

g241351
1. Grease fitting
2. Retaining ring
3. Flange bushing (2 each)
4. Idler arm
5. Torsion spring
Removing the Idler Assembly
Cutting Units: Service and Repairs
6. Flat washer
7. Grease fitting
8. Locknut
9. Flat washer
10. Idler spacer
Note: Refer to Figure 46
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack; refer to the
Groundsmaster 1200 Operator's Manual.
2. Remove the cutting unit covers from the top of the cutting unit.
3. Use a ⅜" or ½" drive ratchet or breaker bar to relieve idler pulley tension
and remove the drive belt.
Figure 46
11.
12.
13.
14.
15.
during this procedure.
Page 6–8 Groundsmaster® 1200 Pull-Behind Rotary Mower
Button head screw
Washer
Cutting unit
Idler pivot
Lock washer
18235SL Rev A