Torsion Axle Assembly - Toro Groundsmaster 1200 Service Manual

Torsion Axle Assembly

g241362
1. Flange head bolt (6 each)
2. Rubber flap
3. Flange head bolt (4 each)
Removing the Torsion Axle Assembly
Chassis: Service and Repairs
4. Nut (4 each)
5. Nut (6 each)
6. Torsion axle
Replacement torsion axle assemblies are supplied with new wheel hub
assemblies already installed.
Note: Refer to Figure 9
1. Park the machine on a level surface, lower the cutting units and disengage
the PTO. Remove the main drive shaft and disconnect the machine
from the tow vehicle. Secure the machine with tow bar jack; refer to the
Groundsmaster 1200 Operator's Manual.
2. Block the wheel that you are not removing with chocks to prevent the
machine from moving.
3. Lift the machine from the ground and support the raised machine with a jack
stand; refer to Groundsmaster 1200 Operator's Manual.
4. Remove the wheel; refer to
Figure 9
7.
during this procedure.
Removing the Wheel (page
Page 3–8 Groundsmaster® 1200 Pull-Behind Rotary Mower
Flap bracket
3–3).
18235SL Rev A