Adapter Cable (6Es5 755-8Ca11); Adapter Cable - Siemens SIMATIC ET 200C Manual

3.13 Adapter Cable (6ES5 755-8CA11)

Application
The adapter cable is required for connecting the programmer (with program-
mer interface module CP5410-S5DOS/ST) or the ET 200 handheld to the
ET 200C.
The programmer or the ET 200 handheld are required for
Characteristics
The adapter cable has the following characteristics:
Connections
The adapter cable has the following connections:
In order to connect the programmer, you also require the programmer con-
necting cable.
Figure 3-13
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b
Setting the station number (digital modules only with ET 200 handheld,
anlog modules optionally with ET200 handheld)
Test and startup
Diagnostics functions
Degree of protection IP 66/IP 67 (see Installation rules, Section 4.1) only
at the end with the IP 66/IP 67 bus connector
Choice of following baud rates:
9.6; 19.2; 93.75; 187.5; 500; 1500; 3000; 6000 or 12000 kbaud
The baud rates 3000, 6000 and 12000 kbaud are only possible when
operating with the IM 308-C and digital modules (see Section 1.2).
Bus connector in IP 20 (9-pin connector)
Bus connector in IP 66/IP 67 (12-pin connector)

Adapter Cable

ET 200C Components
3-23