Connecting The Programmer; Adapter Cable - Siemens SIMATIC ET 200C Manual

Startup and Test with COM ET 200
6.1

Connecting the Programmer

Introduction
There are two options for starting up the ET 200C station with a programmer
and COM ET 200:
Requirements for You will need two cable sets to connect the programmer to the ET 200C
Connecting the module:
Programmer to
ET 200C
Rules for Please observe the following rules when connecting the programmer to
Connecting the
ET 200C modules:
Programmer to
ET 200C
Figure 6-1
6-2
The ET 200C module is disconnected from the bus. You connect the
programmer to the ET 200C module.
You can also start up the ET 200C slave station "bus" while it is in
operation. For this purpose, connect the programmer to the
SINEC L2-DP field bus via the programmer connector.
An adapter cable (see Section 3.13)
and
The programmer connecting cable (Order No. 6XV1 830-1AH..).
The programmer is plugged into the bus connection of the digital modules
via the adapter cable and the programmer connecting cable.
The digital module is run over an external power supply.

Adapter Cable

Programmer
Connecting
Cable
Connecting the Programmer to the ET 200C
External Power
8DI
Supply
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b