Siemens SIMATIC ET 200C Manual page 113

Rules
The rules which apply to setting the station number by means of the DIL
switches in DIL switch block S1 are as follows:
Example
DIL switch block S1 set to station number 6
Figure 4-29
Setting a Station To set a station number by means of the DIL switches in DIL switch block
Number by Means
S1, proceed as follows:
of DIL Switches
1. Open the analog module.
2. On the lower printed-circuit board, set the single switch of DIL switch
3. Set the station number by means of the block of seven DIL switches (see
4. Close the module, making sure that the cover is correctly seated as
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b
The single DIL switch of DIL switch block S1 must be set to M (for
Manual setting via DIL switch). The default setting of this switch is E
(for Electronic setting via the bus).
An ET 200C analog module must be assigned a station number in the
range:
– IM 308-B master interface: 3 ... 124
– IM 308-C master interface: 1 ... 123
You must also enter the same station number when parameterizing with
COM ET 200.
You want to assign station number 6 to an analog module
6 = 2 + 4
Example of How to Set a Station Number at DIL Switch Block S1
block S1 to M (for Manual).
Figure 4-29).
damage may occur if the cover is not aligned with the casing.
Mechanical and Electrical Installation
1
0
1 2 4 8 16 32 64
E
S1
M
4-45