T Connector (6Es5 762-2Ct11) - Siemens SIMATIC ET 200C Manual

3.8

T Connector (6ES5 762-2CT11)

Application
You need a T connector for the following configurations:
This means that the SINEC L2-DP field bus can also continue operating if a
slave station connected via a T connector is disconnected.
Characteristics The T connector has the following characteristics:
Connections
A T connector has 3 bus connections:
The T connector is attached to the bus connection of an ET 200C module via
the 12-pin male connector. Both bus connections of the ET 200C module can
be used.
The bus connection can be used for several purposes (see digital modules).
Figure 3-9
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b
Configuration with power supply connector and with T connectors
(see Section 2.1.2)
Configuration with external current supply (see Section 2.1.4)
Degree of protection IP 66/IP 67 (see Installation rules, Section 4.1)
Choice of following baud rates:
9.6; 19.2; 93.75; 187.5; 500; 1500; 3000; 6000 or 12000 kbaud
The baud rates 3000, 6000 and 12000 kbaud are only possible when the
module is operated with the IM 308-C (see Section 1.2).
Two 12-pin sockets
One 12-pin male connector
T Connector
ET 200C Components
3-17