Startup And Test With Com Et 200 - Siemens SIMATIC ET 200C Manual

Startup and Test with COM ET 200

Startup Options There are 2 options available for starting and testing the ET 200C distributed
I/O station:
Handheld
Start-up and testing of ET 200C using the ET 200 handheld is described in
the ET 200 Handheld manual.
In chapter 8 of this manual you will learn how to
In this Chapter
This chapter describes how to start up and test ET 200C with a programmer
and COM ET 200 V4.x.
You will learn in this chapter how to
COM ET 200 You can skip this chapter if you use ET 200C with COM ET 200 Windows.
Windows
COM ET 200 Windows supports standardized, simple startup for all ET 200
slaves. Its use is not described in this manual. See the manual entitled ET 200
Distributed I/O System (Order No. 6ES5 998-3ES12) for details on which
versions of COM ET 200 Windows incorporate test and startup functions.
The program also has an integral online help system which provides all the
support you need for starting up the ET 200C modules.
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b
Using the ET 200 handheld
Using COM ET 200 and programmer (with interface module
CP5410-S5DOS/ST)
Connect the handheld and which rules you need to observe to do this
(see Section 9.1).
Connect the programmer and the rules you need to observe to do this
(see Section 6.1)
Select the station and transfer the configuration data to the station
(see Section 6.2)
Test the station (see Section 6.3).
6
6-1