Programmer Connector (6Es5 762-2Ca12) - Siemens SIMATIC ET 200C Manual

3.10 Programmer Connector (6ES5 762-2CA12)

Application
A programmer connector is used to connect the programmer within the
IP 66/IP 67 environment to the SINEC L2-DP bus.
Characteristics The programmer connector has the following characteristics:
Connections
A programmer connector has three bus connections:
Figure 3-11
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b
Degree of protection IP 66/IP 67 (see Installation rules, Section 4.1)
Choice of following baud rates:
9.6; 19.2; 93.75; 187.5; 500; 1500; 3000; 6000 or 12000 kbaud
Baud rates 3000, 6000 and 12000 kbaud are possible only for operation
with the IM 308-C and the digital modules (see Section 1.2).
Can be placed anywhere on the bus (exception: the programmer
connector may not be attached to the ends of the bus cable, since there is
then no space for the terminating resistor).
Does not represent a bus node with station number
Attachment without opening the cover (drill-hole template at the back of
the manual).
Connection for "Incoming" SINEC L2-DP field bus (possibly with power
supply) (12-pin socket)
Connection for "Outgoing" SINEC L2-DP field bus (possibly with power
supply) (12-pin socket)
Connection for adapter cable (see Section 3.13) to the programmer
(12-pin socket)
Programmer Connector
ET 200C Components
3-19