Fortinet FortiGate Series Administration Manual page 627

Hide thumbs Also See for FortiGate Series:

Table of Contents

FortiGate Version 4.0 MR1 Administration Guide

01-410-89802-20090903

http://docs.fortinet.com/

The UDP port of the remote host device, or if a NAT device exists in front of the

remote host, the UDP port of the NAT device. Zero (0) indicates that any port can

Proxy ID Source The IP addresses of the hosts, servers, or private networks behind the FortiGate

unit. The page may display a network range if the source address in the firewall

encryption policy was expressed as a range of IP addresses.

When a FortiClient dialup client establishes a tunnel:

If VIP addresses are not used, the Proxy ID Destination field displays the

public IP address of the remote host Network Interface Card (NIC).

If VIP addresses were configured (manually or through FortiGate DHCP

relay), the Proxy ID Destination field displays either the VIP address belonging

to the FortiClient dialup client, or the subnet address from which VIP

addresses were assigned.

When a FortiGate dialup client establishes a tunnel, the Proxy ID Destination field

displays the IP address of the remote private network.

Tunnel up or

A green arrow means the tunnel is currently processing traffic. Select to bring

down the tunnel.

A red arrow means the tunnel is not processing traffic. Select to bring up the

For Dialup VPNs, the list provides status information about the VPN tunnels established

by dialup clients, including their IP addresses. The number of tunnels shown in the list can

change as dialup clients connect and disconnect.

For Static IP or dynamic DNS VPNs, the list provides status and IP addressing information

about VPN tunnels, active or not, to remote peers that have static IP addresses or domain

names. You can also start and stop individual tunnels from the list.

Monitoring VPNs