Fortinet FortiGate Series Administration Manual page 60

Dynamic routing for IPv6 traffic
config aggregate-address
config distribute-list
config interface
60
Use this subcommand to configure aggregate address prefixes.
Variable
edit <entry-id>
prefix6
<aggregate_prefix>
Use this subcommand to filter incoming or outgoing updates using an access list or a
prefix list. If you do not specify an interface, the filter will be applied to all interfaces. You
must configure the access list or prefix list that you want the distribution list to use before
you configure the distribution list. For more information on configuring access lists and
prefix lists, see "router access-list6" on page 51
Note: The direction and listname keywords are required.
All other keywords are optional.
Variable
edit
<distribute_list_id>
direction {in | out}
interface <name_str>
listname
<listname_str>
status
{enable | disable}
Use this subcommand to configure and enable split horizon.
A split horizon occurs when a router advertises a route it learns over the same interface it
learned it on. In this case the router that gave the learned route to the last router now has
two entries to get to another location. However, if the primary route fails that router tries
the second route to find itself as part of the route and an infinite loop is created. A
poisoned split horizon will still advertise the route on the interface it received it on, but it
will mark the route as unreachable. Any unreachable routes are automatically removed
from the routing table. This is also called split horizon with poison reverse.
Note: All keywords are optional.
Description
Enter an entry number for the aggregate address list.
Enter the prefix for the aggregate address.
and
Description
Enter an entry number for the distribution list. The
number must be an integer.
Set the direction for the filter. Enter in to filter incoming
packets. Enter out to filter outgoing packets.
Enter the name of the interface to apply this distribution
list to. If you do not specify an interface, this distribution
list will be used for all interfaces.
Enter the name of the access list or prefix list to use for
this distribution list.
Enable or disable this distribution list.
FortiGate Version 4.0 MR1 Administration Guide
What's new in FortiOS Version 4.0 MR1
Default
::/0
"router prefix-list6" on page
01-410-89802-20090903
http://docs.fortinet.com/
56.
Default
No default.
out
Null.
Null.
disable
• Feedback