Get Router Info6 {Bgp | Ospf | Protocols | Rip - Fortinet FortiGate Series Administration Manual

Hide thumbs Also See for FortiGate Series:

Table of Contents

Dynamic routing for IPv6 traffic

config redistribute

get router info6 {bgp | ospf | protocols | rip}

offset <metric_integer>

status {enable | disable} Enable or disable this offset list.

Use this subcommand to redistribute routes learned from OSPF, BGP, static routes, or a

direct connection to the destination network.

The RIPng redistribution table contains four static entries. You cannot add entries to the

table. The entries are defined as follows:

bgp — Redistribute routes learned from BGP.

connected — Redistribute routes learned from a direct connection to the destination

ospf — Redistribute routes learned from OSPF.

static — Redistribute the static routes defined in the FortiGate unit routing table.

When you enter the subcommand, end the command with one of the four static entry

names (that is, config redistribute {bgp | connected | ospf | static}).

Note: All keywords are optional.

metric <metric_integer>

routemap <name_str>

status {enable | disable} Enable or disable redistributing routes.

Use these commands to display information about the IPv6 dynamic routing protocols.

The get router info6 protocols command returns information about all of the

get router info6 bgp

get router info6 ospf

get router info6 protocols

get router info6 rip

What's new in FortiOS Version 4.0 MR1

Enter the offset number to add to the metric. The

metric is the hop count. The metric_integer

range is from 1 to 16, with 16 being unreachable.

Enter the metric value to be used for the

redistributed routes. The metric_integer range

is from 0 to 16.

Enter the name of the route map to use for the

redistributed routes.

FortiGate Version 4.0 MR1 Administration Guide

01-410-89802-20090903

http://docs.fortinet.com/