Using Filters With Column Settings - Fortinet FortiGate Series Administration Manual

Web-based manager pages

Using filters with column settings

104
• IPSec VPN Monitor (see
• Endpoint NAC list of known endpoints (see
• Log and report log access lists (see
page 720).
Note: Any changes that you make to the column settings of a list are stored in the FortiGate
configuration and will display the next time that you access the list.
To change column settings on a list that supports it, select Column Settings. From
Available fields, select the column headings to be displayed and then select the Right
Arrow to move them to the "Show these fields in this order" list. Similarly, to hide column
headings, use the Left Arrow to move them back to the Available fields list. Use Move Up
and Move Down to change the order in which to display the columns.
For example, you can change interface list column headings to display only the
IP/Netmask, MAC address, MTU, and interface Type for each interface.
Figure 26: Example of interface list column settings
Left Arrow
Figure 27: A FortiGate-5001SX interface list with column settings changed
On firewall policy, IPv6 policy, predefined signature, firewall user monitor, IPSec monitor
and log and report log access lists you can combine filters with column settings to provide
even more control of the information displayed by the list.
"Monitoring VPNs" on page
"Monitoring endpoints" on page
"Accessing and viewing log messages" on
Right Arrow
FortiGate Version 4.0 MR1 Administration Guide
Web-based manager
626)
700)
01-410-89802-20090903
http://docs.fortinet.com/ • Feedback