Fortinet FortiGate Series Administration Manual page 246

SNMP
246
Table 15: Generic FortiGate traps (OID1.3.6.1.4.1.12356.1.3.0)
Trap message
ColdStart
WarmStart
LinkUp
LinkDown
Table 16: FortiGate system traps (OID1.3.6.1.4.1.12356.1.3.0)
Trap message
CPU usage high
(fnTrapCpuThreshold)
Memory low
(fnTrapMemThreshold)
Log disk too full
(fnTrapLogDiskThreshold)
Temperature too high
(fnTrapTempHigh)
Voltage outside acceptable
range
(fnTrapVoltageOutOfRange)
Power supply failure
(fnTrapPowerSupplyFailure)
Interface IP change
(fnTrapIpChange)
Diagnostic trap
(fnTrapTest)
Table 17: FortiGate VPN traps
Trap message
VPN tunnel is up
(fgTrapVpnTunUp)
VPN tunnel down
(fgTrapVpnTunDown)
Local gateway address
(fnVpnTrapLocalGateway)
Remote gateway address
(fnVpnTrapRemoteGateway)
Table 18: FortiGate IPS traps
Trap message Description
IPS Signature IPS signature detected.
(fgTrapIpsSignature)
IPS Anomaly IPS anomaly detected.
(fgTrapIpsAnomaly)
IPS Package Update The IPS signature database has been updated.
(fgTrapIpsPkgUpdate)
(fgIpsTrapSigId) ID of IPS signature identified in trap.
Description
Standard traps as described in RFC 1215.
Description
CPU usage exceeds 80%. This threshold can be set in the CLI using
config system global.
Memory usage exceeds 90%. This threshold can be set in the CLI
using config system global.
Log disk usage has exceeded the configured threshold. Only
available on devices with log disks.
A temperature sensor on the device has exceeded its threshold. Not
all devices have thermal sensors. See manual for specifications.
Power levels have fluctuated outside of normal levels. Not all
devices have voltage monitoring instrumentation.
Power supply failure detected. Not available on all models. Available
on some devices which support redundant power supplies.
The IP address for an interface has changed.
The trap message includes the name of the interface, the new IP
address and the serial number of the Fortinet unit. You can use this
trap to track interface IP address changes for interfaces with
dynamic IP addresses set using DHCP or PPPoE.
This trap is sent for diagnostic purposes.
It has an OID index of.999.
Description
An IPSec VPN tunnel has started.
An IPSec VPN tunnel has shut down.
Address of the local side of the VPN tunnel.
This information is associated with both of the VPN tunnel traps.
Address of remote side of the VPN tunnel.
This information is associated with both of the VPN tunnel traps.
FortiGate Version 4.0 MR1 Administration Guide
System Config
01-410-89802-20090903
http://docs.fortinet.com/ • Feedback