Replacement Messages - Fortinet FortiGate Series Administration Manual

Replacement messages

Replacement messages
250
Table 27: FortiGate Dialup VPNs
MIB field
fgVpnDialupLifetime
fgVpnDialupTimeout
fgVpnDialupSrcBegin
fgVpnDialupSrcEnd
fgVpnDialupDstAddr
fgVpnDialupVdom
Table 28: VPN Tunnel table
MIB field
fgVpnTunEntIndex
fgVpnTunEntPhase1Name
fgVpnTunEntPhase2Name
fgVpnTunEntRemGwyIp
fgVpnTunEntRemGwyPort
fgVpnTunEntLocGwyIp
fgVpnTunEntLocGwyPort
fgVpnTunEntSelectorSrcBeginIp
fgVpnTunEntSelectorSrcEndIp
fgVpnTunEntSelectorSrcPort
fgVpnTunEntSelectorDstBeginIp
fgVpnTunEntSelectorDstEndIp
fgVpnTunEntSelectorDstPort
fgVpnTunEntSelectorProto
fgVpnTunEntLifeSecs
fgVpnTunEntLifeBytes
fgVpnTunEntTimeout
fgVpnTunEntInOctets
fgVpnTunEntOutOctets
fgVpnTunEntStatus
fgVpnTunEntVdom
Go to System > Config > Replacement Message to change replacement messages and
customize alert email and information that the FortiGate unit adds to content streams such
as email messages, web pages, and FTP sessions.
Description
VPN tunnel lifetime in seconds.
Time remaining until the next key exchange (seconds) for this tunnel.
Remote subnet address of the tunnel.
Remote subnet mask of the tunnel.
Local subnet address of the tunnel.
The virtual domain this tunnel is part of. This index corresponds to the
index in fgVdTable.
Description
An index value that uniquely identifies a VPN tunnel within
the VPN tunnel table.
The descriptive name of the Phase1 configuration for the
tunnel.
The descriptive name of the Phase2 configuration for the
tunnel.
The IP of the remote gateway used by the tunnel.
The port of the remote gateway used by the tunnel, if it is
UDP.
The IP of the local gateway used by the tunnel.
The port of the local gateway used by the tunnel, if it is UDP.
Beginning of the address range of the source selector.
Ending of the address range of the source selector.
Source selector port.
Beginning of the address range of the destination selector.
Ending of the address range of the destination selector.
Destination selector port.
Protocol number for the selector.
Lifetime of the tunnel in seconds, if time based lifetime is
used.
Lifetime of the tunnel in bytes, if byte transfer based lifetime
is used.
Timeout of the tunnel in seconds.
Number of bytes received on the tunnel.
Number of bytes sent out on the tunnel.
Current status of the tunnel - either up or down.
Virtual domain the tunnel belongs to. This index
corresponds to the index used in fgVdTable.
FortiGate Version 4.0 MR1 Administration Guide
System Config
01-410-89802-20090903
http://docs.fortinet.com/ • Feedback