Router Ospf6 - Fortinet FortiGate Series Administration Manual

Dynamic routing for IPv6 traffic

router ospf6

52
Use this command to configure OSPF routing for IPv6 traffic.
Syntax
router ospf6
set abr-type {cisco | ibm | standard}
set auto-cost-ref-bandwidth <mbps_integer>
set default-metric <metric_integer>
set passive-interface <name_str>
set router-id <address_ipv4>
set spf-timers <delay_integer> <hold_integer>
config area
edit <area_address_ipv4>
set default-cost <cost_integer>
set stub-type {no-summary | summary}
set type {regular | stub}
end
config ospf6-interface
edit <ospf_interface_name>
set area-id <ip4_addr>
set cost <cost_integer>
set dead-interval <seconds_integer>
set hello-interval <seconds_integer>
set interface <name_str>
set priority <priority_integer>
set retransmit-interval <seconds_integer>
set status {enable | disable}
set transmit-delay <seconds_integer>
end
end
config redistribute
set metric <metric_integer>
set metric-type {1 | 2}
set routemap <name_str>
set status {enable | disable}
end
end
Variable
abr-type {cisco | ibm |
standard}
auto-cost-ref-bandwidth
<mbps_integer>
default-metric
<metric_integer>
What's new in FortiOS Version 4.0 MR1
{bgp | connected | rip | static}
Description
Specify the behavior of a FortiGate unit
acting as an OSPF area border router
(ABR) when it has multiple attached areas
and has no backbone connection.
Selecting the ABR type compatible with
the routers on your network can reduce or
eliminate the need for configuring and
maintaining virtual links. For more
information, see RFC 3509.
Enter the Mbits per second for the
reference bandwidth. Values can range
from 1 to 65535.
Specify the default metric that OSPF
should use for redistributed routes. The
valid range for metric_integer is 1 to
16777214.
FortiGate Version 4.0 MR1 Administration Guide
Default
standard
1000
10
01-410-89802-20090903
http://docs.fortinet.com/ • Feedback