Configuring Dhcp Services - Fortinet FortiGate Series Administration Manual

Configuring DHCP services

Configuring DHCP services
228
Go to System > DHCP > Service to configure DHCP services. On each FortiGate
interface, you can configure a DHCP relay or add DHCP servers as needed.
On FortiGate 50 and 60 series units, a DHCP server is configured, by default, on the
Internal interface, as follows:
IP Range 192.168.1.110 to 192.168.1.210
Netmask 255.255.255.0
Default gateway 192.168.1.99
Lease time 7 days
DNS Server 1 192.168.1.99
You can disable or change this default DHCP Server configuration.
Note: You can not configure DHCP in Transparent mode. In Transparent mode DHCP
requests pass through the FortiGate unit.
Note: An interface must have a static IP before you configure a DHCP server on it.
These settings are appropriate for the default Internal interface IP address of
192.168.1.99. If you change this address to a different network, you need to change the
DHCP server settings to match.
Figure 102: DHCP service list - FortiGate-200A shown
Interface List of FortiGate interfaces. Expand each listed interface to view the Relay and
Servers.
Server Name/ Name of FortiGate DHCP server or IP address of DHCP server accessed by
relay.
Relay IP
Type Type of DHCP relay or server: Regular or IPSec.
Enable Green check mark icon indicates that server or relay is enabled.
Add DHCP Server Select to configure and add a DHCP server for this interface.
icon
Add DHCP Server
FortiGate Version 4.0 MR1 Administration Guide
01-410-89802-20090903
http://docs.fortinet.com/
System DHCP
Edit
Delete
• Feedback