Fortinet FortiGate Series Administration Manual page 200

Configuring the modem interface
200
If the modem is disabled it will not appear in the interface list, and must be enabled from
the CLI using:
config system modem
set status enable
end
Note: You cannot configure and use the modem in Transparent mode.
Figure 84 shows the only the settings specific to standalone mode. The remaining settings
are common to both standalone and redundant modes and are shown in
Figure 84: Modem settings (Standalone)
Figure 85: Modem settings (Redundant)
Enable Modem Select to enable the FortiGate modem.
Modem status Modem status can be: not active, connecting, connected, disconnecting,
or hung up.
FortiGate Version 4.0 MR1 Administration Guide
01-410-89802-20090903
http://docs.fortinet.com/
System Network
Figure 85.
• Feedback