Setting The Parameters In The Installer Level; Reading Out Measured Values; Reading Current Values - REMEHA Gas 210 ECO PRO Series Installation, User And Service Manual

Fig.34 Access to the installer level
4x
2x
9.3

Reading out measured values

114494 - v.05 - 06022018
Caution
Modification of the factory settings may impair boiler operation.
9.2.1

Setting the parameters in the Installer level

Parameters at installer level (see table of parameters) may be modified
only by a recognised installer. To prevent unwanted modifications to set­
tings, some parameters can only be changed after the special access
code
1. Navigate to the Installer menu.
The
2. Select the installer menu using the
3. Using the
4. To confirm, press the
appears.
5. Press the
The value
6. Change the value by pressing the
to °C, for example, using the
7. Press the
appears.
8. Set any other parameters by selecting them using the
9. Press the
Important
The main menu will appear even if no keys are pressed for 3 mi­
nutes.
AD-4000048-01
The control unit continually registers various values from the boiler and the
connected sensors. These values can be read on the control panel of the
boiler.
See
See control panel manual
9.3.1

Reading current values

The following current values can be read in the information menu
= status
= sub-status
= Flow temperature (°C)
= Return temperature (°C)
= Outside temperature (°C); is only indicated when outside sensor
is connected.
= boiler block temperature (°C)
= Internal set point (°C).
= ionisation current (uA)
= fan speed (rpm)
= Water pressure (bar).
= Supplied relative heat output (%).
is entered.
symbol flashes in the menu bar.
appears on the display.
or keys, set the installer code
key.
key.
°C will appear (factory setting).
key to confirm the value.
key twice to go back to the main display.
9 Settings
key.
.
or keys. Reduce the value
key.
or keys.
:
49