Accessing The Installer Level; Commissioning The Appliance - REMEHA Quinta Ace 30 Service Manual

Fig.6 Menu selection
22/02/2018 11:20 Home Screen
Not set
... ...
........ .......
......
Fig.7 Confirm menu selection
22/02/2018 11:20 Home Screen
Not set
... ...
........ .......
......
4.2

Accessing the installer level

Fig.8 Installer level
00:12 ........ ....... ........ ......... ...
..... ... ....... .... .. ..... ....... .... ..... .......
i
........ .......
0
0 0 1
1 1 2
2 2 3
3 3 4
4 4 5
Fig.9 Installer level
........ ....... ........ ......... ...
00:12
..... ... ....... .... .. ..... ....... .... ..... .......
i
........ .......
0
0 0 1
1 1 2
2 2 3
3 3 4
4 4 5
4.3

Commissioning the appliance

7703943 - v.06 - 13122021
........ .......
AD-3001387-01
........ .......
AD-3001388-01
0
1
2
3
4
5
6
AD-3001378-02
0
1
2
3
4
5
6
AD-3001378-02
1. Use the rotary knob to select the required menu.
2. Press the button to confirm the selection.
The available settings of this selected menu appear in the display.
3. Use the rotary knob to select the desired setting.
4. Press the button to confirm the selection.
All options for change will appear in the display (if a setting cannot
be changed, Cannot edit read-only datapoint will appear in the
display).
5. Use the rotary knob to change the setting.
6. Press the button to confirm the selection.
7. Use the rotary knob to select the next setting or press the
return to the home screen.
Some settings are protected by installer access. Enable installer access in
order to change these settings.
Use the rotary knob to navigate.
Use the button to confirm your selection.
1. Access the installer level via the tile:
1.1. Select the tile [
1.2. Use code: 0012.
The tile [ ] shows that the installer access is On, and the
icon in the top right of the display changes into
2. Access the installer level via the menu:
2.1. Select Enable installer access from the Main Menu.
2.2. Use code: 0012.
When the installer level is enabled or disabled, the status of
the tile [ ] changes into On or Off.
When the control panel is not used for 30 minutes, the installer access is
disabled automatically. You can manually disable installer access by:
Selecting the tile [ ].
Selecting Disable installer access from the Main Menu.
At first start-up of the appliance, the display will show the commissioning
wizard. Depending on the appliance, some steps take a few minutes to
complete, for example appliances that need to deaerate after installation
or need to configure a boiler.
Use the rotary knob to navigate.
Use the button to confirm your selection.
1. Start up the appliance.
4 Installer instructions
].
button to
.
9