Modification Of The Installer-Level Parameters; Setting The Maximum Heat Input For Central Heating Operation; Calora Tower Gas 35S Ex; Calora Tower Gas 15S Ex Calora Tower Gas 25S Ex - REMEHA CALORA TOWER GAS 15S EX Installation And Service Manual

CALORA TOWER GAS 15S EX CALORA TOWER GAS 25S EX

CALORA TOWER GAS 35S EX

3x
2x
22/04/2016 - 300026141-001-07
6.7.2.
Parameters p17 to df must only be modified by a qualified
professional. To prevent unwanted settings, some parameter settings
can only be changed after the special access code 0012 is
entered.
1. Press the two keys f simultaneously and then key [+] until the
2. Select the fitter menu using the  key. c0de appears on the
3. Use keys [-] or [+] to input the installer code 0012 .
4. Confirm using key S . p[1 is displayed with 1 flashing.
5. Press the S key a second time. The value 80 °C appears and
6. Change the value by pressing the [-] or [+] key. In this example
7. Confirm the value with the S key: p[1 is displayed with 1
T000819-E
8. If necessary, set other parameters by selecting them using the
9. Press the > key 2 times to return to the current operating
6.7.3.
The speed can be changed using parameter p17. To do this,
proceed as follows:
Modification of the installer-level
parameters
CAUTION
Modification of the factory settings may be detrimental to
the functioning of the appliance.
symbol ? flashes on the menu bar.
display.
flashes (for example).
using key [-] to 60 °C.
flashing.
[-] or [+] keys.
mode.
The boiler also returns to operating status if no keys are
pressed for 3 minutes.
Setting the maximum heat input for central
heating operation
6. Commissioning
73